Door Trim Service Hole Cover

REMOVAL

Remove the parts in the numerical order shown in the figure.

Fig. 12-41

Fig. 12-41

Land Cruiser Door Trim Parts

1. Window Regulator Handle

2. Armrest or Pull Handle

3. Door Inside Handle Bezel

4. Door Trim Board

5. Door Inside Handle

6. Service Hole Cover

Fig. 12-42

f <(Q

1 ^N .

0 Before removing the handle, pull off the snap ring with a cloth and remove the window regulator handle.

Fig. 12-43

Fig. 12-43

Insert a screwdriver between the panel and panel retainers and pry out.

Fig. 12-44

Insert a screwdriver between the panel and panel retainers and pry out.

Fig. 12-44

Remove the inside handle. 1. Disconnect the link.

2. Remove the handle.

INSTALLATION

Install the parts in numerical order shown in the figure.

Fig. 12-45

2 Fig. 12-49

Service Hole Cover Door Inside Handle Door Trim Board

Door Inside Handle Bezel Armrest or Pull Handle Window Regulator Handle

Fig. 12-46

Fig. 12-46

Seal the service hole cover with adhesive.

Fig. 12-47

Fig. 12-47

0 Insert the lower edge of the service hole cover into the panel slit.

Fig. 12-48

Fig. 12-48

Seal the service hole cover with cotten-_ covered tape.

Do not block the trim board clip seating with the tape.

Adjust the link play 1 Loosen the screws.

2. Move the handle forward to the point where strong resistance is felt. 3 Move handle back 0.5 - 1.0 mm (0.020 -0.039 in.) and tighten

Fig. 12-50

Fig. 12-50

Raise the window to the fully closed position.

Install the door inside handle as shown in the figure.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • yolando
    How to replace a toyota corolla car manual window handle?
    6 years ago

Post a comment