Door Trim Service Hole Cover

REMOVAL

1. Lower the door glass to full down position.

2. Remove the parts in the numerical order shown in the figure.

Toyota Land Cruiser Cover

1. Window Regulator Handle 5. Door Inside Handle

2. Armrest or Pull Handle 6. Service Hole Cover 3 Door Inside Handle Bezel 7. Door

4. Door Trim Board

0 Before removing the handle, pull off the snap ring with a piece of cloth and remove the window regulator handle.

Insert a screwdriver between the door panel and retainers and pry out.

Tape the screwdriver tip before use.

Insert a screwdriver between the door panel and retainers and pry out.

Tape the screwdriver tip before use.

Disconnect the control link and remove the inside handle.

Bony a j

instal ln$ta" tlle Partc fl9ure tS 'n th° numen

LATIQN

ical order shown

Door Hole Cover

1 Door

Fig. 12-10

Fig. 12-12

Fig. 12-13

Fig. 12-10

Seal the service hole cover with adhesive.

0 Insert the lower edge of the service hole cover into the panel slit.

Fig. 12-12

0Seal the service hole cover with cotton-covered tape.

Do not block the trim board clip seating with the tape.

Fig. 12-13

Toyota Sequoia Door Handle Cable

Adjust the link play.

1. Loosen the screws.

2. Move the handle forward to the point where strong resistance is felt.

3 Move handle back 0.5 - 1.0 mm (0.020 -0 039 in.) and tighten

Door Peephole Cover
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • Pia Barese
    How to remove Land Cruiser door handles?
    7 years ago

Post a comment