Fuel Gauge

CIRCUIT DIAGRAM

Fig. 13-141

FJ Series

BJ, HJ Series

Ignition Relay

Ignition Relay

(0.85R)

Fig. 13-142

Fig. 13-142

ON-VEHICLE INSPECTION

1. Pull the connector out of the fuel sender gauge and ground it through a 3.4W bulb.

2. After the ignition switch is turned ON, the bulb should start flashing with in several seconds, and the gauge needle should vibrate.

Fig. 13-145

INSPECTION

1. Measure the resistance between terminals B and D.

Resistance: STD 25 i!

2. When the ignition switch is turned ON with a connector connected to the control panel, voltage should be applied to the terminal A.

3. Under the above condition, 2—7V of current should be applied to terminals B and D.

(A regulator is built into the fuel receiver gauge.)

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment