Heater Control

REMOVAL

Remove the parts in the numerical order shown in the figure.

Fig. 13-195

3 Fig 13-197

13-199

13-198

Battery Terminal Combination Meter Center Cluster Duct

Knob

Heater Contr panei Blower Swit

Fig. 13-196

I Before removing the combination meter, pull out the cable while pushing the lock lever.

Push

Fig. 13-196

Push

Fig. 13-197

Fig. 13-197

Before removing the center panel, disconnect the connectors.

Fig. 13-199

0 Disconnect the fore cables from their clamps.

INSTALLATION

Install the parts in the numerical order shown in the figure.

Fig. 13-200

1.

Blower Switch

2

Heater Control Panel

3.

Knob

4.

Duct

5.

Center Cluster

6

Combination Meter

7.

Battery Terminal

Fig. 13-201

Fig. 13-201

Connect the cables as shown in the figure.

Fig. 13-202

Fig. 13-202

0 Before installing the center panel, connect the connectors.

Fig. 13-203

Fig. 13-203

Install the knobs and retainer and make sure that the knobs are tight.

Fig. 13-204

Fig. 13-204

| | Connect each cable to each control lever and clamp the cables.

Fig. 13-205

6. Check to see that the control lever is properly aligned by checking the air dis-, charge at each position, and check the lever stiffness and stroke.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment