Oil Pressure Receiver Gauge

ON-VEHICLE INSPECTION

1. Pull the connector out of the oil pressure sender gauge and ground it through a 3.4W bulb.

2. After the ignition switch is turned ON, the bulb should light up and the gauge needle should deflect.

Fig. 13-152

Fig. 13-152

Fig. 13-153

: Battery

INSPECTION

1. Measure the resistance between terminals 4 and 5.

2. When the ignition switch is turned ON with a connector connected to the control panel, voltage should be applied to terminal G.

Resistance: 65 H

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment