Propeller Shaft

COMPONENTS

DOUBLE CARDAN TYPE

REMOVAL

Remove the parts in the numerical order shown in the figure.

DOUBLE CARDAN TYPE

FRONT & REAR

DOUBLE CARDAN TYPE

Propeller Toyota Land Cruiser

1 Bolt & Nut 2. Bolt & Nut or Nut 3 Propeller Shaft

INSPECTION Propeller Shaft

1. Place matchmarks on the sleeve yoke and propeller shaft, and remove the sleeve yoke.

Toyota Propeller Shaft Lubrication 2015

2. Inspect the propeller shaft for runout. Runout:

Limit 0.8 mm

Propeller Shaft Repair

Propeller Shaft & Sliding Yoke

Inspect for wear or damage.

Spider Bearing

Inspect for wear or damage. Spider axial play: Less than 0.05 mm

Double Cardan Type Propeller Shaft - Note -

If any problem is found, replace the front propeller shaft assembly. Do not disassemble.

Propeller Shaft Repair

Replace The Spider Bearing

1. Place matchmarks on the flange yoke, spider and sleeve yoke (or propeller shaft).

Toyota Propeller Shaft Lubrication 2015

2. Remove the grease fitting and the snap rings.

3. Screw out the bearing outer race about 5 mm (0.20 in.) with SST. SST [09332-25010]

Cruiser Propeller Shaft

4. Clamp the bearing outer race in a vise and remove it by tapping the sleeve yoke.

Remove the other bearing outer race of the sleeve yoke and the two bearing outer races of flange yoke by the same procedure.

5. Aline matchmarks on flange yoke spider and sleeve yoke.

Matchmarks

Matchmarks

Front

No. 1 Sleeve Yoke

No. 1 Sleeve Yoke

Sleeve Yoke No. 1 Fitting n0. 2 Fitting\ I /Fitting

The figure at the left is the grease fitting as seen from the rear.

Sleeve Yoke No. 1 Fitting n0. 2 Fitting\ I /Fitting

The figure at the left is the grease fitting as seen from the rear.

6. When replacing the spider, be sure that the grease fitting assembly holes are facing in the direction shown in the figure.

Coat the bearing rollers with MP grease and fit them into the outer races.

Toyota Propeller Shaft Lubrication 2015

Screw in the bearing outer races on both sides with SST until the snap ring grooves are at maximun and equal width. SST [09332-25010]

Select and install a sanp ring which will provide minimum play. Snap ring thickness

Part No.

Thickness mm (in.)

09520-29286

1.475 - 1.525 (0.0581 - 0.0600)

09520-29287

1.525 - 1.575 (0.0600 - 0.0620)

09520-29288

1.575 - 1.625 (0.0620 - 0.0640)

Do not reuse snap rings. !\ Use the snap rings of the same thickness on both sides.

10. Lightly tap the yoke to firmly set the bearing outer race.

11. Check to see that the spider moves smoothly.

Check for axial play.

Spider axial play: Less than 0.05 mm

Mr2 Mk2 Prop

12 Install the grease fitting.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment