Roof headlining

REMOVAL

Remove the parts in the numerical order shown in the figure.

Fig. 12-196

Toyota Tacoma Roof Replacement

1.

Sun Visor & Hanger

11.

Deck Side Trim

2

Inner Rear View Mirror

12

Back Door Weatherstrip

3.

Interior Light

13.

Rear Piller Garnish

4.

Front Door Opening Trim

14.

Inside Rear Trim

5.

Assist Grip

15.

Front Windshield & Weatherstrip

6.

Rear Door Opening Trim

16.

Quarter Window Glass & Weatherstrip

7.

Shoulder Anchor Bolt

17.

Clip

8

Center Pillar Garnish

18.

Roof Headlining & Support

9

Luggage Compartment Light

19.

Roof Headlining Support

10

Quarter Window Inside Trim

20.

Roof Headlining

Fig. 12-197

Front

0 Remove the clips as shown in the figure. Peel off the glued parts of the headlining.

Fig. 12-198

Support

Headlining

Support

Headlining

VJLlj _jhi I

Support / Support Retainer

Remove the supports in turn, begining with the rear.

Fig. 12-199

Fig. 12-199

0 Compress the support inward at boih ends, turn it 180° forward and remove it frr?m the hole.

Do not turn the support more than 180°.

INSTALLATION

Install the parts in the numerical order shown in the figure.

Fig. 12-200

2 Fig. 12-201 12-206

Roof Headlining

Roof Headlining Support Roof Headlining & Support Clip

Quarter Window Glass & Weatherstrip

Front Windshield Glass & Weatherstrip

Inside Rear Trim

Rear Pillar Garnish

Back Door Weatherstrip

Deck Side Trim

Quarter Window Inside Trim

11.

Luggage Compartment Light

12

Center Pillar Garnish

13.

Shoulder Anchor Bolt

14.

Rear Door Opening Trim

15.

Assist Grip

16.

Front Door Opening Trim

17.

Interior Light

18.

Inner Rear View Mirror

19

Sun Visor & Hanger

2 Fig. 12-201 12-206

Fig. 12-201

Install from the rear to front. - Note -

Be sure the rear is in position.

Fig. 12-202

Fig. 12-202

Insert the support with retainer into the hole, revolve 180° upward and install.

Fig. 12-203

Adhesive

Fig. 12-204

Adhesive iihlm

0 Apply adhesive to the headlining circumference.

Apply adhesive to the body and headlining Weatherstrip adhesive: Part No. [08704-00010]

Attach the headlining by stretching it out in the directions shown by arrows.

Fig. 12-205

Fig. 12-205

Install the clips.

Fig. 12-206

Install the clips.

Fig. 12-206

If there are any wrinkles remaining, use an infrared light for a short time while pressing out the wrinkles.

Be careful not to overheat the area.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment