Steering Column Main Shaft Fj Bj Hj Series

REMOVAL

Remove the steering column.

Toyota Sienna 2006 Intermediate Steering

DISSAEMBLY

Disasemble the parts in the numerical order shown in the figure.

Fig. 8-115

Column Cover Combination Switch Ignition Key Cylinder

4 Upper Bracket 5. Main Shaft

Fig. 8-117

Remove the snap ring with SST. SST [09905-00012]

Fig. 8-118

INSPECTION & REPAIR gjH Main Shaft

1. Check the shaft for damage or berding.

Fig. 8-119

2. Check the spider bearing for wear or damage.

Fig. 8-120

INTERMEDIATE SHAFT SECTION Fig. 8-8 to 8-16

Replace The Spider Bearing

Replace the spider bearing.

Fig. 8-121

Fig. 8-121

Upper Bracket

1. Check the steering lock system.

Fig. 8-122

Fig. 8-122

2. Check the bearing for rotation condition.

Fig. 8-123

Fig. 8-123

Replace The Upper Bearing

Remove the bearing. 2. Install the bearing until its upper surface is even with the bracket surface.

Fig. 8-124

Fig. 8-125

Fig. 8-124

Column Tube & Hole Cover

Check for wear or damage.

Fig. 8-125

Lower Bearing

Check for rotation condition.

Fig. 8-126

Fig. 8-126

0 Replace The Lower Bearing

1. After place matchmarks, separate the tube from the tube support.

Fig. 8-127

Fig. 8-127

Fig. 8-128

vf 0

Fig. 8-129

2. Remove the hole cover.

vf 0

3. Remove the snap ring and bearing.

4. Install the new bearing and snap ring.

Fig. 8-130

Fig. 8-130

5. Install the dust seal on the bearing.

6. Install the hole cover.

Fig. 8-131

7. Align the matchmarks and temporarily tighten the tube clamp bolt.

After installing the steering column on the vehicle, retighten the it.

ASSEMBLY

Assemble the parts in the numerical order shown in the figure.

Fig. 8-132

1 Fig. 8-133 8-134

1. Main Shaft

2. Upper Bracket

3. Ignition key Cylinder 4 Combination Switch 5. Column Cover

Fig. 8-134

Apply MP grease to the dust seal and make sure it doesn't turn over when inserting the main shaft.

Fig. 8-136

install the snap ring with SST. SST [09905-00012]

install the snap ring with SST. SST [09905-00012]

Fig. 8-136

Turn the key to the ACC position, and install the key cylinder.

Fig. 8-137

Fig. 8-137

Fig. 8-139

TILT TYPE STEERING COLUMN & MAIN SHAFT INSTALLATION SECTION Fig. 8-101 to 8-113

Be sure the screws are put in the proper places when installing the column cover.

Install the connector on the lower cover.

INSTALLATION

Install the steering column.

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment