Water Temperature Receiver Gauge

ON-VEHICLE INSPECTION

1. Pull the connector out of the water temperature sender gauge and ground through a 3.4W bulb.

2 When the ignition switch is turned ON, the bulb should start flashing with in several seconds, and the gauge needle should vibrate.

Fig. 13-148

Fig. 13-149

777TT, h

INSPECTION (Bimetal Type)

1. Measure the resistance between ter-. minais E and F.

Resistance: STD 25 i)

2. When the ignition switch is turned ON with a connector connected to the control panel under the above condition, 2 - 7 V current should be applied to the terminal A.

(A regulator is built into the fuel receiver gauge.)

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment