Atf Temperature Sensor Onvehicle Repair

1. REMOVE ENGINE NO.2 UNDER COVER

2. DRAIN ATF

3. REMOVE OIL PAN (See page AT-11)

4. REMOVE OIL STRAINER (See page AT-1 1)

5. REMOVE ATF TEMPERATURE SENSOR

(a) Disconnect the 7 solenoid valve connectors.

(b) Remove the 2 bolts and disconnect the 2 ATF temperature sensors.

(c) Disconnect the solenoid connector.

(d) Remove the bolt and the transmission wire harness 6. INSTALL ATF TEMPERATURE SENSOR

(a) Install the transmission wire harness.

(b) Install the bolt.

(c) Connect the solenoid connector.

(d) Connect the 7 solenoid valve connectors.

(e) Connect the 2 ATF temperature sensors with the 2 bolts Torque:

A: 11 Nm (112 kgf-cm, 8 ftlbf) B: 10 Nm (100 kgf-cm, 7 ftlbf) Bolt length:

Bolt A: 36 mm (1.42 in.) Bolt B: 12 mm (0.47 in.) Sensor wire harness:

Wire harness

Color

for linear control

Orange

for oil temp warning lamp

Blue

7. INSTALL OIL STRAINER (See page AT-8 )

9. FILL ATF AND CHECK ATF LEVEL (See page AT-3-1 )

10. INSTALL ENGINE NO.2 UNDER COVER

Was this article helpful?

0 0

Post a comment