Disassembly

1. PULL OUT EVAPORATOR TEMPERATURE SENSOR

2. REMOVE EXPANSION VALVE

Using a hexagon wrench (5.0mm, 0.20 in.), remove the 2 bolts and separate the expansion valve and the evaporator.

Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT:

At the time of reassembly, lubricate 4 new O-rings with compressor oil and install them to the valve. If evaporator is replaced, add compressor oil to the evaporator. Add: 40 cc (1.4 fl.oz.) Compressor oil: ND-OIL8 or equivalent

_AIR CONDITIONING - FRONT A/C EVAPORATOR_

AC1LD-04

INSPECTION

1. CHECK EVAPORATOR FINS FOR BLOCKAGE

If the fins are clogged, remove them with compressed air. NOTICE:

Never use water to clean the evaporator.

2. CHECK FITTINGS FOR CRACKS OR SCRATCHES

If necessary, repair or replace.

3. INSPECT EVAPORATOR TEMPERATURE CIRCUIT (See page DI-1322 )

INSTALLATION

Installation is in the reverse of removal (See page AC-75 ).

Was this article helpful?

0 0

Post a comment