Inspection

1. REMOVE FRONT SEATS

2. REMOVE REAR CONSOLE BOX

3. REMOVE FRONT CONSOLE BOX COVER

4. REMOVE LOWER CENTER CLUSTER FINISH PANEL

5. REMOVE FRONT DOOR SCUFF PLATES

6. REMOVE COWL SIDE TRIMS

7. REMOVE REAR DOOR SCUFF PATES

8. REMOVE CENTER PILLAR GARNISHES

9. REMOVE AIR INLET TEMPERATURE SENSOR (a) Slide the floor carpet backward.

(b) Disconnect the connector.

(c) Remove the screw and the air inlet temperature sensor.

10. INSPECT AIR INLET TEMPERATURE SENSOR CIRCUIT (See page DI-1342)

11. INSTALL AIR INLET TEMPERATURE SENSOR

(a) Install the air inlet temperature sensor with the screw.

(b) Connect the connector.

(c) Install the floor carpet.

12. INSTALL CENTER PILLAR GARNISHES

13. INSTALL REAR DOOR SCUFF PLATES

14. INSTALL COWL SIDE TRIMS

15. INSTALL FRONT DOOR SCUFF PLATES

16. INSTALL REAR CONSOLE BOX

17. INSTALL FRONT SEATS

Was this article helpful?

0 0

Post a comment