Install Valve Body

HINT:

Align the groove of the manual valve with the pin of the lever. (a) Install the 3 new drum seal gaskets to the transmission case.

(b) Install the 19 bolts and the valve body. Torque:

BoltA.B: 11 Nm (110 kgfcm, 8 ftlbf) Bolt length:

12. CONNECT TEMPERATURE SENSOR

(a) Connect the 2 temperature sensors to the valve body, anc install the 2 temperature sensors clamp with the 2 bolts Torque:

A: 11 Nm (112 kgfcm, 8 ftlbf) B: 10 Nm (100 kgfcm, 7 ftlbf) Bolt length:

Bolt A: 36 mm (1.42 in.) Bolt B: 12 mm (0.47 in.) Sensor wire harness:

Wire harness

Color

for linear control

Orange

for oil temp warning lamp

Blue

13. CONNECT 7 CONNECTORS TO SHIFT SOLENOID VALVES

13. CONNECT 7 CONNECTORS TO SHIFT SOLENOID VALVES

14. INSTALL OIL STRAINER

(b) Install the oil strainer with the 4 bolts. Torque: 10 Nm (100 kgfcm, 7 ftlbf)

15. INSTALL OIL PAN

HINT:

Remove any packing material, and be careful not to spill oil on the contacting surfaces of the transmission case and the oil pan.

(a) Install a new gasket and oil pan.

(b) Install the 20 bolts and oil pan. Torque: 4.4 N-m (45 kgf-cm, 39 in-lbf)

16. FILL ATF AND CHECK ATF LEVEL

(a) Install a new gasket and a drain plug. Torque: 20 Nm (204 kgfcm, 15 ftlbf)

(b) Remove the refill plug.

(c) Fill new fluid through the refill hole (See page AT-3-1 ).

17. INSTALL ENGINE NO.2 UNDER COVER

0 0

Post a comment