Mm in

If the clearance is not within the standard clearance, adjust the clearance using shims to obtain the standard clearance. Shim thickness: 0.1 mm (0.004 in.) 0.3 mm (0.012 in.) 0.5 mm (0.020in.)

N04963

AIR CONDITIONING - COMPRESSOR AND MAGNETIC CLUTCH_

AC1IM-03

REMOVAL

1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES

2. STOP ENGINE

3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY

4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

5. REMOVE ENGINE UNDER COVER

6. REMOVE DRIVE BELT (See page AC-16 )

7. DISCONNECT DISCHARGE AND SUCTION HOSES

Remove the 2 bolts and disconnect the both hoses. NOTICE:

Cap the open fittings immediately to keep moisture or dirt out of the system.

8. REMOVE FRONT DRIVE SHAFT LH (See page SA-26)

9. REMOVE COMPRESSOR

(a) Disconnect the connector.

(b) Remove the 3 bolts and the compressor

_AIR CONDITIONING - CONDENSER_

AC1IR-04

Was this article helpful?

0 0

Post a comment