Onvehicle Repair

1. REMOVE ENGINE NO. 2 UNDER COVER

2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

3. REMOVE PARK/NEUTRAL POSITION SWITCH

(a) Pry off the lock washer and remove the nut.

(b) Remove the bolt and park/neutral position switch.

4. INSTALL PARK/NEUTRAL POSITION SWITCH

(a) Install the park/neutral position switch with the bolt. Torque: 13 Nm (130 kgfcm, 9 ftlbf)

(b) Install a new lock washer and the nut. Torque: 6.9 Nm (70 kgfcm, 62 in.lbf)

(c) Bent the claws on the lock washer to stake the nut.

(d) Adjust the park/neutral position switch (See page DI-361 ).

5. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

6. INSTALL ENGINE NO. 2 UNDER COVER

Connector A Connector B G--ACC P1

KLS+

SLS+

SLS+

SLS-

Was this article helpful?

0 0

Post a comment