Removal

1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

HINT:

At the time of installation, refer to the following items evacuate air from the refrigeration system and charge system with the refrigerant and inspect for leaks of the refrigerant.

Specified amount: 1,050 ± 50 g (37.03 ± 1.76 oz.)

2. REMOVE RADIATOR GRILL

3. REMOVE A/T AIR COOLED OIL COOLER (See page AT-17)

4. REMOVE ENGINE UNDER COVER

5. REMOVE DISCHARGE TUBE

(a) Remove the bolt and disconnect the tube from the condenser.

(b) Loosen the nut and remove the tube. Torque: 22 Nm (225 kgfcm, 16 ftlbf)

NOTICE:

Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT:

At the time of installation, lubricate 2 new O-rings with compressor oil and install them on the tube.

6. DISCONNECT LIQUID TUBE

Remove the bolt and disconnect the tube.

Torque: 10 Nm (100 kgfcm, 7 ftlbf) NOTICE:

Cap the open fittings immediately to keep moisture or dirt out of the system.

HINT:

At the time of installation, lubricate a new O-ring with compressor oil and install them on the tube.

Was this article helpful?

0 0

Post a comment