Remove Crossmember And Transter Case Protector

(a) Support the transmission with a jack.

(b) Remove the 3 bolts and the transter case protector. Torque: 29 Nm (296 kgfcm, 21 ftlbf)

(c) Remove the 8 bolts, the 2 nuts and the crossmember Torque:

Bolt: 50 Nm (510 kgfcm, 37 ftlbf) Nut: 74 Nm (750 kgfcm, 54 ftlbf)

15. REMOVE ENGINE MOUNTING INSULATOR RR

Remove the 4 bolts and the engine mounting insulator RR. Torque: 59 Nm (600 kgfcm, 43 ftlbf)

HINT:

At the time of installation, install the insulator rear with the inscribing mark facing backward.

16. REMOVE TRANSMISSION

(a) Lower the rear end of the transmission unit.

(b) Remove the transmission wire clamp bolt.

(c) Remove the 10 bolts and the transmission unit. Torque:

Bolt A: 71 Nm (724 kgfcm, 52 ftlbf) Bolt B: 37 Nm (377 kgfcm, 27 ftlbf)

17. REMOVE WIRE HARNESS AND HOSE

(b) Release the lock and disconnect the connector.

(c) Disconnect the 5 connectors.

(d) Separate the 6 connector clamps.

(e) Disconnect the 5 hoses and remove the wire harness and the hose.

Was this article helpful?

0 0

Post a comment