Remove Rotor

(a) Using SST, remove the snap ring. SST 95994-10020

Snap Ring

R-Shape Rotor

R-Shape Rotor

Compressor

NOTICE:

At the time of reassembly, the snap ring should be installed so that beveled side facing up.

AC1743

(b) Using a plastic hammer, tap the rotor off the shaft. NOTICE:

Be careful not to damage the pulley when tapping on the rotor.

AC1743

3. REMOVE STATOR

(a) Disconnect the stator lead wire from the compressor housing.

(b) Using SST, remove the snap ring. SST 95994-10020

NOTICE:

At the time of reassembly, the snap ring should be installed so that its beveled side facing up.

(c) Remove the stator.

Was this article helpful?

0 0

Post a comment