Disassembly Of Compressor

1. REMOVE FELT

Toyota Hj62

2. REMOVE SNAP RING

Using SST, remove the snap ring. SST 07114-84020

2. REMOVE SNAP RING

Using SST, remove the snap ring. SST 07114-84020

3. REMOVE KEY

Remove the key from the shaft. SST 071 12-45021

3. REMOVE KEY

Remove the key from the shaft. SST 071 12-45021

4. APPLY COMPRESSOR OIL TO INNER BORE

Apply compressor oil to the inner bore of the compressor.

5. REMOVE SEAL PLATE

(a) Insert SST against the shaft. Then push the holder ring downward.

SST 07112-15010

(b) Pull up the remover bar, and remove the seal plate.

6. REMOVE SHAFT SEAL

Insert SST against the shaft, and turn it to the right while pressing on the remover.

Then remove the shaft seal.

SST 07114-15010

Sst 07110 61050

7. REMOVE SERVICE VALVE

(a) Using SST, remove the bolts holding the service valve.

SST 07110-61050

(b) Remove the O-ring from the service valve and discard them.

8. DRAIN COMPRESSOR OIL INTO MEASURING FLASK

Measure the quantity of drained oil because the same amount should be replaced later.

AC1126

9. REMOVE REVOLUTION DETECTING SENSOR (4A-GZE ENGINE ONLY)

AC1126

10. REMOVE FRONT HOUSING

(a) Using SST, remove the five through bolts. NOTE: Do not reuse the five washers. SST 07110-61050

(b) Using a screwdriver, remove the front housing.

CAUTION: Be careful not to scratch the sealing surface of the front housing.

11. REMOVE FRONT VALVE PLATE

Remove the two pins from the front housing. Discard the pins.

Mr2 Aw11 Restoration

12. REMOVE REAR HOUSING

Using a screwdriver, remove the rear housing.

CAUTION: Be careful not to scratch the sealing surface of the rear housing.

13. REMOVE FRONT AND REAR O-RINGS FROM CYLINDER BLOCK

Discard the O-rings.

Toyota Landcruiser Magnetic Clutch

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • STACY
    How to remove magnetic clutch?
    8 years ago

Post a comment