Disconnect Parking Brake Cable

(a) Remove the pin clip.

(b) Pull out the hole pin while pushing the parking brake cable.

(c) Remove the clip.

(d) Remove the parking brake cable from the cable support bracket.

REMOVE CYLINDER

Remove the installation bolt, and remove the brake cylinder.

4. REMOVE PADS

Parking Brake Toyota Corolla E11

c9959 c9960

Eye Safety

c9959 c9960

DISASSEMBLY OF CYLINDER

1. REMOVE SLIDING BUSHING AND BOOT

c9961

2. REMOVE MAIN PIN BOOT

c9961

3. REMOVE CYLINDER BOOT SET RING AND CYLINDER BOOT

Using a screwdriver, remove the cylinder boot set ring and cylinder boot.

c9963

4. REMOVE PISTON FROM CYLINDER

Using SST, turn the piston counterclockwise and remove it.

SST 09719-14020 (09719-00020)

c9963

Sst 09719 14020

5. REMOVE PISTON SEAL FROM CYLINDER

Using a screwdriver, remove the piston seal.

6. REMOVE SNAP RING FROM CYLINDER

(a) Set SST onto the adjusting bolt, and lightly tighten it with a 14 mm socket.

SST 09756-00010

CAUTION:

• To insure safety, always use SST as there is a possibility of the spring flying out, causing injury or damaging to the interior surface of the cylinder.

• Be careful not to tighten the SST too tightly as this may damage the spring retainer.

(b) Using snap ring pliers, remove the snap ring from the cylinder.

c9967

7. REMOVE ADJUSTING BOLT

From the cylinder, pull out the spring retainer, spring, spring plate and stopper together with the adjusting bolt.

CAUTION:

• Be careful not to damage the O-ring.

09756 00010

8. DISASSEMBLE ADJUSTING BOLT

(a) Remove SST. SST 09756-00010

(b) Remove the spring retainer, spring, spring plate and stopper from the adjusting bolt.

(c) Remove the O-ring from the adjusting bolt.

9. REMOVE STRUT

10. REMOVE TORSION SPRING FROM PARKING BRAKE CRANK

11. REMOVE PARKING BRAKE CRANK FROM CYLINDER

12. REMOVE PARKING BRAKE CRANK BOOT

Using a screwdriver, lightly tap on the metal portion of the boot and remove it.

NOTE: Do not remove the boot unless replacing it.

13. REMOVE CABLE SUPPORT BRACKET

14. REMOVE STOPPER PIN

Using a pin punch, tap out the pin.

14. REMOVE STOPPER PIN

Using a pin punch, tap out the pin.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • KLAUS
    How to slide the parking brake cable out the clip from a toyota?
    8 years ago

Post a comment