1. REMOVE HUB BEARING CAP
(a) Clamp the steering knuckle in a soft jaw vice.
(b) Using a screwdriver and hammer, remove the hub bearing cap.
REMOVE FRONT AXLE HUB LOCK NUT
(a) Clamp the axle hub in soft jaw vice.
HINT: Close vice until it holds hub bolt. Do not tighten further.
(b) Using a hammer and chisel, loosen the staked part of the nut and remove the lock nut.
REMOVE SPEED SENSOR ROTOR
NOTICE: Take care to not scratch the serrations of speed sensor rotor.
REMOVE BEARING INNER SPACER
REMOVE AXLE HUB
(a) Remove the disc brake dust cover.
(b) Using SST, remove the axle hub from the steering knuckle.
REMOVE HUB BEARING
(a) Using snap ring pliers, remove the hole snap ring.
(b) Using SST, remove the hub bearing inner race (outside) from the axle hub.
(c) First place the removed inner race (outside) in the bearing.
(d) Using SST, drive out the hub bearing from the steering knuckle.
Was this article helpful?