Info

REMOVE PISTON RINGS

(a) Using a piston ring expander, remove the two compression rings.

(b) Remove the two side rails and oil ring expander by hand.

HINT: Arrange the rings in correct order only.

3. DISCONNECT CONNECTING ROD FROM PISTON

(a) Using a small screwdriver, pry out the two snap rings.

(b) Gradually heat the piston to 80 - 90°C (176 -194°F).

(c) Using plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

HINT:

• The piston and pin are a matched set.

• Arrange the pistons, pins, rings, connecting rods and bearings in correct order.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment