Inspection Of Hightension Cords

1. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS

Disconnect the high-tension cords at rubber boot. DO -NOT pull on the cords.

NOTICE: Pulling on or bending the cords may damage the conductor inside.

2. DISCONNECT HIGH-TENSION CORD FROM IGNITION COIL (See step 3 on pages IG-14 and 15)

3. REMOVE DISTRIBUTOR CAP WITHOUT DISCONNECTING HIGH-TENSION CORDS

4. INSPECT HIGH-TENSION CORD RESISTANCE

Using an ohmmeter, measure the resistance without disconnecting the distributor cap.

Maximum resistance: 25 kQ per cord

If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord and/ or distributor cap.

5. REINSTALL DISTRIBUTOR CAP

6. RECONNECT HIGH-TENSION CORD TO IGNITION COIL (See step 5 on pages IG-16 and 17)

7. RECONNECT HIGH-TENSION CORDS TO SPARK PLUGS

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment