Installation Of Throttle Body

1. INSTALL ISC VALVE TO THROTTLE BODY (See step 1 on page FI-153)

2. INSTALL THROTTLE BODY

(a) Place a new gasket on the throttle body, facing the protrusion downward.

Sw20 Throttle Body

(b) Install the throttle body with the four bolts.

HINT: Each bolt is indicated in the figure.

Toyota Camry Throttle Body Pipes

3. CONNECT HOSES TO THROTTLE BODY

(a) Water by-pass hose from water outlet

(b) Water by-pass hose from water by-pass pipe

Avalon Egr Setup

(e) Two vacuum hoses from EGR vacuum modulator

(f) Vacuum hose from EGR VSV

4. CONNECT ISC VALVE CONNECTOR

5. CONNECT THROTTLE POSITION SENSOR CONNECTOR

6. INSTALL AIR CLEANER

(See step 35 on page EM-226)

7. CONNECT ACCELERATOR CABLE, AND ADJUST IT

CONNECT THROTTLE CABLE, AND ADJUST IT

9. FILL WITH ENGINE COOLANT (See page CO-7)

10. INSTALL LH ENGINE HOOD SIDE PANEL

11. CONNECT CABLE TO NEGATIVE TERMINAL OF BATTERY

Was this article helpful?

+1 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • roma
    How to bypass throttle body water lines mr2?
    8 years ago

Post a comment