Output Of Diagnostic Codes

To obtain an output of diagnostic codes, proceed as follows:

1. Initial conditions

(a) Battery voltage 11 V or more

(b) Throttle valve fully closed (throttle position sensor IDL points closed)

(c) Transmission in neutral position

(d) Accessories switched OFF

(e) Engine at normal operating temperature

2. Turn the ignition switch to ON. Do not start the engine.

3. Using SST, connect terminals TE1 and E1 of the check connector.

SST 09843-18020

Wk(

Y

fi1405

4. Read the diagnostic code as indicated by the number of flashes of the "CHECK" engine warning light.

OFF-

at0716

Diagnostic Codes (See page Fl-28 or 30)

(a) Normal System Operation (no malfunction)

• The light will alternately blink ON and OFF 2 times per second.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • elisa
    How to check engine light code sw20?
    8 years ago

Post a comment