Removal Of Distributor

RH Engine Hood Side Panel

Distributor

RH Engine Hood Side Panel

Distributor

No.2 Engine Under Cover

^Engine Under Cover Bracket

Distributor Connector

No.1 Engine Under Cover

No.2 Engine Under Cover

Distributor Connector

^Engine Under Cover Bracket

No.1 Engine Under Cover

♦ Non-reusable part ig1375

1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY

CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.

2. DISCONNECT DISTRIBUTOR CONNECTOR

3. DISCONNECT HIGH-TENSION CORD FROM IGNITION COIL (See procedure step 3 on pages IG-14 and 15)

4. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS

(a) Disconnect the cord clamp from the engine hanger.

(b) Disconnect the four high-tension cords from the spark plugs. (See page IG-11)

5. REMOVE DISTRIBUTOR

(a) Remove the hold-down bolt and pull out the distributor.

(b) Remove the O-ring from the distributor housing.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment