Removal Of Distributor

RH Engine Hood Side Panel

Distributor

RH Engine Hood Side Panel

Distributor

No.2 Engine Under Cover

Distributor Connector

No.1 Engine Under Cover

No.2 Engine Under Cover

Distributor Connector

No.1 Engine Under Cover

Engine Under Cover Bracket

♦ Non-reusable part ig1374

1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY

CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.

2. DISCONNECT DISTRIBUTOR CONNECTOR

3. DISCONNECT HIGH-TENSION CORD FROM IGNITION COIL

(a) Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coil.

(b) Disconnect the high-tension cord at the grommet. DO NOT pull on the cord.

NOTICE: Pulling on or bending the cords may damage the conductor inside.

4. DISCONNECT HIGH-TENSION CORDS FROM SPARK

PLUGS

(a) Disconnect the four high-tension cords from the cord clamp.

(b) Disconnect the four high-tension cords from the spark plugs. (See page IG-6)

5. REMOVE DISTRIBUTOR

(a) Remove the two hold-down bolts, and pull out the distributor.

(b) Remove the O-ring from the distributor housing.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment