3S-GTE
Starter Wire
Terminal Cover -
Wire Clamp
Starter Wire
Terminal Cover -
Air Flow Meter Connector
LH Engine Hood Side Panel
Starter. Cable
Wire Clamp
Air Cleaner Cap
— Air Cleaner f Element
Air Cleaner Case
Air Cleaner Cap
— Air Cleaner f Element
Air Cleaner Case
5S-FE
LH Engine Hood Side Panel
-Air Cleaner Cap
Air Cleaner Element
-Air Cleaner Case
LH Engine Hood Side Panel
Starter Wire
Intake Air Temp. Sensor Connector
-Air Cleaner Cap
Air Cleaner Element
-Air Cleaner Case
Starter Wire st0888 st0898
1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY
CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.
2. REMOVE LH ENGINE HOOD SIDE PANEL
3. REMOVE AIR CLEANER
3S-GTE (See step 9 on page EM-134) 5S-FE (See step 9 on page EM-182)
4. REMOVE STARTER
(a) Remove the terminal cover.
(b) Remove the nut, and disconnect the starter cable.
(c) Remove the nut, and disconnect the starter wire.
(d) Disconnect the starter connector.
(e) Remove the two bolts, wire clamp and starter.
Was this article helpful?
Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.