Replacement Of Front Axle Hub Bolt

1. REMOVE BRAKE CALIPER

Remove the brake caliper from the steering knuckle and suspend it with a wire.

2. REMOVE ROTOR DISC

Align the matchmarks, and install the rotor disc to the axle hub.

SA1685

3. REMOVE FRONT AXLE HUB BOLT

(a) Align the disc brake dust cover cutting portion and axle hub bolt.

(b) Using SST, remove the axle hub bolt. SST 09628-10011

SA1698

4. INSTALL FRONT AXLE HUB BOLT

(a) Install a new hub bolt from the backing plate side.

(b) Install the suitable plate washer and nut.

(c) Tighten the nut, while holding the axle hub.

5. INSTALL ROTOR DISC

Align the matchmarks and install the rotor disc to the axle hub.

sa1718

6. INSTALL DISC BRAKE CALIPER TO STEERING KNUCKLE

Install and torque the two bolts. Torque: 600 kg-cm (43 ft-lb, 59 N-m)

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment