Replacement Of Rear Axle Shaft Bolt

1. DISCONNECT BRAKE CALIPER FROM AXLE CARRIER

Disconnect the brake caliper from the axle carrier and suspend it with wire.

SA1720

Www Repairsurge Com

2. REMOVE ROTOR DISC

HINT: Before removing the rotor disc, place the match-marks on the axle shaft and rotor disc.

3. REMOVE REAR AXLE SHAFT BOLT

(a) Align the brake dust cover cut portion and axle shaft bolt.

(b) Using SST, remove the axle shaft bolt. SST 09628-10011

4. INSTALL REAR AXLE SHAFT BOLT

(a) Install a new bolt from the backing plate side.

(b) Install the suitable plate washer and nut.

(c) Tighten thé nut, while holding the axle shaft.

6. INSTALL DISC BRAKE CALIPER TO REAR AXLE CARRIER

Install and torque the two bolts. Torque: 600 kg-cm (43 ft-lb, 59 N-m)

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment