Inspection Procedure

Total OBD & ECU Auto Diagnostics

TOAD Auto Diagnostics

Get Instant Access


(a) Turn the ignition switch ON.

(b) Measure voltage between terminals Ts and CG of DLC3 OK:

If ABS warning light does not blink even after Ts and CG are connected, the ECU may be defective.

2 Check for open and short circuit in harness and connector between brake ECU and DLC3, DLC3 and body ground (See page IN-41).

Check and replace brake ECU.





Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook

Post a comment