Inspection Procedure

1 Check voltage between terminals WL of EMPS ECU connector and body ground.

PREPARATION:

Remove the EMPS ECU with connectors still connected. CHECK:

Turn the ignition switch ON and measure the voltage between terminals WL of EMPS ECU connector and body ground. OK:

2 Check for open and short circuit in harness and connector between EMPS ECU and multiinformation display (See page IN-41).

Check multiinformation display circuit (See page BE-97).

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment