Inspection

HINT:

This check is used only to determine whether or not the idle CO/HC complies with regulations.

1. INSTALL CONDITIONS

(a) Air cleaner installed

(b) Air pipes and hoses of air induction system connected

(c) All accessories switched OFF

(d) All vacuum lines properly connected

(e) EFI system wiring connectors fully plugged

(f) Ignition timing check correctly

(g) Transmission in parking range

(h) Tachometer and CO/HC meter calibrated by hand

2. ACTIVATE INSPECTION MODE AND WARM UP ENGINE (See page IN-10)

3. RACE ENGINE AT 2,250 RPM FOR APPROX. 180 SECONDS

HINT:

At the accelerator opening angle of 60% or more, the engine speed is controlled at 2,250 rpm.

4. INSERT CO/HC METER TESTING PROBE AT LEAST 40 cm (1.3 ft) INTO TAILPIPE DURING IDLING

5. IMMEDIATELY CHECK CO/HC CONCENTRATION AT IDLE AND/OR 2,250 RPM

Complete the measuring with 3 minutes. HINT:

When doing the 2 mode (idle and 2,250 rpm) test, these measurement order prescribed by the applicable local regulations.

6. STOP ENGINE

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment