Preparation

(a) Turn the ignition switch to LOCK.

(b) Disconnect negative (-) terminal cable from the battery, and wait at least for 90 seconds.

(c) Disconnect the airbag sensor assembly connector.

(d) Insert service wire into terminal TC from back side as shown in the illustration.

(e) Connect the airbag sensor assembly connector with service wire.

(f) Connect negative (-) terminal cable to the battery.

(g) Turn the ignition switch to ON, and wait at least for 20 seconds.

(h) Connect service wire of terminal TC to body ground. CHECK:

Check operation of the SRS warning light. OK:

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment