Table Of Contents

Adjusting and operating features such as door locks, mirrors, and steering column Driving, stopping and safe-driving information Air conditioning and audio systems, as well as other interior features for a comfortable driving experience Cleaning and protecting your vehicle, performing do-it-yourself maintenance, and maintenance information What to do if the vehicle needs to be towed, gets a flat tire, or is involved in an accident Reporting safety defects for U.S. owners and seat belt...

Info

N Effective range (areas within which the electronic key is detected) The system can be operated when the electronic key is within about 2.3 ft. (0.7 m) of f outside front and back door or When starting the hybrid J' system or changing POWER switch modes The system can be operated when the electronic key is inside the vehicle. A buzzer sounds and the emergency flashers flash to indicate that the doors have been locked unlocked. (Locked Once Unlocked Twice) n When the door cannot be locked using...

Taking out the jack

Toyota Rav4 2016 Jack

After storing the jack, make sure it is securely held by the tightening strap. Loosen the center fastener that secures the spare tire. Behind the rear right-hand side tire In front of the front right-hand side tire In front of the front left-hand side tire Vehicles with a 15 inch wheel, remove the wheel ornament using the wrench. To protect the wheel ornament, place a rag between the wrench and the wheel ornament, as shown in the illustration. Slightly loosen the wheel nuts one turn . Turn the...

Installation with LATCH system

Toyota Yaris 2000 Isofix Tether Strap

StepQ Widen the gap between the seat cushion and seatback slightly. STEp2 Latch the hooks of the lower straps onto the LATCH anchors. STEp3 If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor. For owners in Canada The symbol on a child restraint system indicates the presence of a lower connector system. step T Widen the gap between the seat cushion and seatback slightly. STEp2 Latch the buckles onto the LATCH anchors. STEp3 If...

Turning on the high beam headlights

With the headlights on, push the lever forward to turn on the high beams. Pull the lever back to the center position to turn the high beams off. Release the lever to turn them off. e You can flash the high beams dr with the headlights on or off. lt n Daytime running light system if equipped To make your vehicle more visible to other drivers, the headlights turn on automatically at a reduced intensity whenever the hybrid system is started and the parking brake is released. Daytime running...

Hybrid System Indicator

The Hybrid System Indicator displays the hybrid system operating condition and provides environmentally friendly fuel efficient driving assistance in accordance with the driving conditions and the operation of the accelerator pedal. Hybrid battery traction battery status Eco Driving Indicator Light Lights up when the vehicle is being driven in an environmentally friendly manner. Displays the average vehicle speed since the function was last reset. The function can be reset by pressing and...

Hillstart assist control

Prius Hill Start Assist

N Hill-start assist control operating conditions The system operates in the following situations The shift position is in other than P. The parking brake is not applied. The accelerator pedal is not depressed. n Hill-start assist control l While hill-start assist control is operating, the brakes remain automatically applied after the driver releases the brake pedal. The stop lights and the high mounted stoplight turn on. l Hill-start assist control operates for about 2 seconds after the brake...

Changing shift ranges to P position

Manual Pedal Icons

Push the P position switch with the brake pedal pressed down. The P position icon is displayed on the instrument cluster, and the indicator on the P position switch comes on. You can only shift to other positions from P when the brake pedal is depressed. When parking, check that the P position icon is displayed on the instrument cluster, and release the brake pedal gently after applying the parking brake. To use the engine braking, shift the shift lever to B position. l During high speed...

Headlight cleaner switch

Headlight Cleaner Switch

N The headlight cleaner can be operated when The POWER switch is in ON mode and the headlight switch is turned on. If equipped, the headlight switch is in the AUTO position and the headlight is on. n Windshield washer linked operation When the windshield washer is operated with the POWER switch in ON mode and the low beam headlights on, the headlight cleaner will operate once. P. 210 n When the washer fluid tank is empty Do not use this function when the washer fluid tank is empty. This may...

Indicators and warning lights

Toyota Prius Warning Lights Guide

The indicator and warning lights on the instrument cluster and instrument panel inform the driver of the status of the vehicle's various systems. The indicators inform the driver of the operating state of the vehicle's various systems. Headlight high beam indicator P. 206 Headlight indicator usa. 206 Cruise SET indicator H-P. 214 Cruise main indicator vehicle-to-vehicle distance mode H-P. 218 AIR BAG ON OFF indicator P. 126 Eco Driving Mode indicator P. 172 READY indicator H-P. 162 n If a...

If your vehicle overheats

The following may indicate that your vehicle is overheating l The high coolant temperature warning light comes on or flashes The engine may be overheating. l HYBRID SYSTEM OVERHEAT is shown on the multi-information display The power control unit may be overheating. Follow the correction procedure as described below. n If the high coolant temperature warning light comes on or flashes stepQ Stop the vehicle in a safe place and turn off the air conditioning system. STEp2 Check to see if steam is...

N Front fog lights vehicles with LED headlights

How Turn The Back Fog Lights Prius

Bolt and clip and pull down the engine under cover. Unplug the connector while pushing the lock release. Turn the bulb base counterclockwise. tep T Remove the engine under cover bolt and clip and pull down the engine under cover. P. 479 n Rear turn signal lights and back-up lights Open the back door and remove the cover. Turn the bulb base counterclockwise. Open the back door and remove the cover. To protect the cover, place a rag between the flathead screwdriver and cover as shown in the...

If the volt battery is discharged

Exclusive Jump Starting Terminal Toyota

The following procedures may be used to start the hybrid system if the vehicle's 12 volt battery is discharged. You can call your Toyota dealer or qualified repair shop. If you have a set of jumper or booster cables and a second vehicle with a 12 volt battery, you can jump start your Toyota following the steps below. Open the exclusive jump starting terminal cover. Exclusive jump starting terminal on your vehicle Positive battery terminal on the second vehicle B Negative - battery terminal on...

Doityourself service precautions

If you perform maintenance yourself, be sure to follow the correct procedure given in these sections. Conventional wrench for terminal clamp bolts Engine power control unit coolant level Toyota Super Long Life Coolant or similar high quality ethylene glycol based non-silicate, nonamine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology. Toyota Super Long Life Coolant is pre-mixed with 50 coolant and 50 deionized water. For Canada Toyota Super Long Life Coolant is...

Installing towing eyelet

Remove the eyelet cover using a flathead screwdriver. To protect the bodywork, place a rag between the screwdriver and the vehicle body, as shown in the illustration. Insert the towing eyelet into the hole and tighten partially by hand. Tighten down the towing eyelet securely using a wheel nut wrench. n Location of the emergency towing eyelet n Installing towing eyelet to the vehicle Make sure that towing eyelet is installed securely. If not securely installed, towing eyelet may come loose...

N Jack point guide

Toyota Yaris Jack Point

The jack point guides are located under the rocker panel. They indicate the jack point positions. Improper use of the tire jack may lead to death or serious injuries due to the vehicle suddenly falling off the jack. l Do not use the tire jack for any purpose other than replacing tires or installing and removing tire chains. l Only use the tire jack that comes with this vehicle for replacing a flat tire. Do not use it on other vehicles, and do not use other tire jacks for replacing tires on this...

Smart key system without entry function

Antena Smart Key System Toyota

Starting and stopping the hybrid system can be performed simply by carrying the electronic key on your person, for example in your pocket. The driver should always carry the electronic key. I Antenna location and effective range n Effective range areas within which the electronic key is detected When starting the hybrid system or changing POWER switch modes The system can be operated when the electronic key is inside the vehicle. Make sure to carry the electronic key when operating the system....

Checking and replacing fuses

How Remove Toyota Prius Fuses

If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. step T Turn the POWER switch OFF. Vehicles with Solar Ventilation System Turn the Solar Ventilation System off and make sure not to operate the Remote Air Conditioning System. step 2 Open the fuse box cover. Engine compartment sTEPj3 After a system failure, see Fuse layout and amperage ratings P. 465 for details about which fuse to check. IsTEPjs Check if the...

Hybrid system

Toyota Prius Hybrid Batteries Air Intake

It has characteristics different from conventional vehicles. Be sure you are closely familiar with the characteristics of your vehicle, and operate with care. The hybrid system combines a gasoline engine and an electric motor traction motor according to driving conditions, improving fuel efficiency and reducing exhaust emissions. Electric motor Traction motor The gasoline engine stops when the vehicle is stopped. During take-off, the electric motor traction...

N If Hybrid System Overheat is shown on the multiinformation display

Prius Coolant System

StepQ Stop the vehicle in a safe place and turn off the air conditioning system. STEp2 Leave the hybrid system operating and carefully lift the hood. Check if the cooling fans are operating. If the fans are operating Wait until HYBRID SYSTEM OVERHEAT disappears and then stop the hybrid system. If the message does not disappear, call your Toyota dealer. If the fans are not operating Stop the hybrid system immediately and call your Toyota dealer. After the hybrid system has cooled down, check the...