Smart key system without entry function

Starting and stopping the hybrid system can be performed simply by carrying the electronic key on your person, for example in your pocket.

(The driver should always carry the electronic key.)

Corolla Smart Key System

I Antenna location and effective range"

n Antenna location

Antena Smart Key System Toyota

Antennas inside cabin n Effective range (areas within which the electronic key is detected)

When starting the hybrid system or changing "POWER" switch modes

The system can be operated when the electronic key is inside the vehicle.

Class Seat

n Conditions affecting operation

n Electronic key battery depletion

n To operate the system properly

Make sure to carry the electronic key when operating the system.

Depending on the position and holding condition of the electronic key, the key may not be detected correctly and the system may not operate properly. (The alarm may go off accidentally, or the door lock prevention may not function.)

n Note for the smart key system l Even when the electronic key is within the effective range (detection areas), the system may not operate properly.

For example, the electronic key is on the instrument panel, luggage cover, floor or in the glove box when the hybrid system is started or "POWER" switch modes are changed.

l Even if the electronic key is not inside the vehicle, it may be possible to start the hybrid system if the electronic key is near the window.

n Alarms and warning indicators

A combination of exterior and interior alarms are used to prevent theft of the vehicle and unforeseeable accidents resulting from erroneous operation. Take appropriate measures according to the warning message shown on the multi-information display. (^P. 508)

The following table describes circumstances and correction procedures when only alarms are sounded.

Alarm

Situation

Correction procedure

Exterior alarm sounds once for 10 seconds

An attempt was made to lock the vehicle while a door is open

Close all of the doors and lock the doors again

Interior alarm pings continu-ously*1

The "POWER" switch was turned to ACCESSORY mode while the driver's door was open (or the driver's door was opened while the "POWER" switch was in ACCESSORY mode)

Turn the "POWER" switch OFF and close the driver's door

Interior alarm sounds continu-ously*1

When the "POWER" switch is in ON mode or ACCESSORY mode, an attempt was made to open the door and exit the vehicle, and the shift position was not in "P"

Push the "P" position switch and turn the "POWER" switch OFF

Interior and exterior alarms sound continuously*1

When the "POWER" switch is in ON mode or ACCESSORY mode, the driver's door was closed after the key was carried outside the vehicle, and the shift position not in "P"

Push the "P" position switch, turn the "POWER" switch OFF and close the driver's door again

*1: A message will be shown on the multi-information display in the instrument cluster.

*2: If the hybrid system does not start when the electronic key is inside the vehicle, the electronic key battery may be depleted or there may be difficulties receiving signal from the key. (^P. 541)

n If the smart key system does not operate properly

n When the electronic key battery is fully depleted

n Customization that can be configured at Toyota dealer

Settings (e.g. smart key system) can be changed.

(Customizable features ^P. 587)

Alarm

Situation

Correction procedure

Interior alarm pings once*1

The electronic key has a low battery

Replace the electronic key battery

An attempt was made to start the hybrid system without the electronic key being present, or the electronic key was not functioning normally

Start the hybrid system with the electronic key present*2

Interior alarm pings once and exterior alarm sounds 3 times*1

The driver's door was closed after the key was carried outside the vehicle, and the "POWER" switch was not turned OFF

Turn the "POWER" switch OFF and close the driver's door again

An occupant carried the electronic key outside the vehicle and closed the door while the "POWER" switch was not OFF

Bring the electronic key back into the vehicle

*1: A message will be shown on the multi-information display in the instrument cluster.

n Certification for the smart key system

► For vehicles sold in the U.S.A. FCC ID: NI4TMLF8-2

FCC ID: HYQ14ACX FCC ID: HYQ14ADF FCC ID: HYQ13CZD FCC ID: HYQ13CZE

NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING:

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

► For vehicles sold in Canada NOTE:

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

A CAUTION

n Caution regarding interference with electronic devices

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • imogen crawford
    Where is the toyota rav 4 smartkey antenna?
    8 years ago
  • Portia
    How to start prisus 2010 with out elctronic key?
    8 years ago

Post a comment