Exs

NOTE Only perform these installation steps if the RES harness and V5 harness are being installed simultaneously. (jj) Locate the RES harness' relay and V5 harness' relay from the steering column area, then secure two relays with large foam tape. (Fig. 2-23) (kk)Route the RES harness and V5 harness toward the center cluster area. (Fig. 2-24) (ll) Secure the 4P connector and relay to the RES harness and V5 harness with two wire ties. Secure the RES harness and V5 harness to the driver side metal...

Under Hood

01 Check engine oil and ATM fluid levels 02 Check brake fluid level 03 Check engine coolant level 04 Check battery state-of-charge using MICROPRO 815 Digital Analyzer 05 Inspect for fuel, oil, coolant, and other fluid leaks . . 01 Remove disc brake anti-rust covers anti-corrosion wheel film 02 Activate tire pressure monitor 03 Inspect tires for defects damage 04 Install rubber body plugs 05 Install wheel covers caps spare tire wheel covers . 06 Inspect for fuel, oil, coolant, and other fluid...

Fuse Box Cover

(k) Without towing package only (l). (l) Apply label (included in kit) to the position on the fuse box cover reverse side as shown. (Fig8-5) (m) If the part of the fuel tank cable with yellow tape comes off from the vehicle clamp, attach it to the vehicle clamp. (Fig. 8-6) (n) Put Owner's Manual into the glove box.

Programming

The RS3200 Plus is factory-set to not Passively Arm. To change the system's operation for Passive Arming operation, as well as adjust the Entry Delay time, follow the procedure below. For more information on this feature, please refer to page 7. PASSIVE ARMING ON OFF SELECTION, ENTRY DELAY TIME SELECTION 2. Insert and remove the key from the ignition key cylinder 3 times this must be completed within 5 seconds. Lock and unlock all doors 3 times by key or remote control. Lock, then unlock the...

Radar Sensor Off Mode

PERFORM THE FOLLOWING The LED turns off. The system is now DISARMED. 2. Lock, then unlock the driver's door inside lock button 3 times, within 5 seconds. 4. ARM the system with the remote control or key while the LED is blinking.THE RADAR SENSOR will deactivate during arming. NOTE If you disarm the system after you set the radar sensor OFF, you have to repeat the above procedure when you arm the system if you want to deactivate the radar sensor again. the...

Remove Oil Filter Cap Assembly

Rav4 Oil Filter Cap

HINT The drain pipe is supplied with the oil filter element. b Remove the oil filter drain plug and O-ring, and then insert the drain pipe into the oil filter cap and drain the engine oil into a container. c Make sure that oil is completely drained, and remove the pipe and O-ring. HINT Be sure to turn the pipe in the direction of the arrow to remove it. d Using SST, remove the oil filter cap together with the oil filter element. SST 09228-06501 a Remove the oil...

Nbey

The point at which the air bubbles disappear in the refrigerant of the sub-cool cycle is lower than the proper amount of refrigerant with which the system must be filled. Therefore, if the system is recharged with refrigerant based on the point at which the air bubbles disappear, the amount of refrigerant would be insufficient. As a result, the cooling performance of the system will be affected. If the system is overcharged with refrigerant, this will also lead to a reduced performance. For the...