Pat

(r) Plug in the RES harness' white 8P

connectors between the vehicle harness' 8P connector and the ignition switch. (Fig. 2-10) (1) Verify the connectors are plugged in securely.

(s) Secure the 8P connector to the vehicle harness with one wire tie. (Fig. 2-10) CAUTION: Position the 8P connector exactly as shown. Otherwise, when other vehicle parts are placed, serious damage may occur to the vehicle parts or accessories.

(1) Do not secure the air bag harness (yellow connector wires).

(2) After securing the connector, temporarily install the steering column cover and check if tilt and telescopic movement of the steering is smooth and not interfered by any object.

(t) Secure the RES harness to the vehicle harness with one wire tie. (Fig. 2-10) (1) After securing the RES harness, temporarily install adjacent vehicle parts carefully and make sure no wires are being pinched or pressed.

Vehicle Harness' 2P

Vehicle Harness' 2P

V5 Harness' 2P

RES Harness'4P (Black)

RES Harness

RES Harness'4P (Black)

RES Harness

RES Harness' 8P

Vehicle Harness' 8P

V5 Harness' Fig. 2-13 V5 Harness 4P (Black)

RES Harness' 8P

V5 Harness' Fig. 2-13 V5 Harness 4P (Black)

RES Harness' 8P

Vehicle Harness' 8P

RES Harness' 8P

FOR RES HARNESS and V5 HARNESS SIMULTANEOUS INSTALLATION ONLY. (Steps u-w)

NOTE: Only perform these installation steps if the RES harness and V5 harness are being installed simultaneously.

(u) Locate and disconnect the white 2P and white 8P connector from the ignition switch area. (Fig. 2-11)

(v) Plug in the V5 harness' white 2P connectors between the vehicle harness' 2P connector and the ignition switch. (Fig. 2-12)

(w) Plug in the V5 harness' white 8P connectors between the vehicle harness' 8P connector and the ignition switch. (Fig. 2-13)

Side Cutter /

Wire Tie

Side Cutter /

Wire Tie

FOR RES HARNESS and V5 HARNESS SIMULTANEOUS INSTALLATION ONLY. (Step x)

0 0

Post a comment