Operation

PASSIVE (AUTOMATIC) ARMING & DISARMING

When the RS3200 Plus is programmed to PASSIVELY ARM, the system will ARM after the ignition key is removed and all doors are closed; you do not need to lock the doors. When you come back to your vehicle and open a door, you must insert the key into the ignition switch and turn it to "ON" during the Entry Delay (0, 15 or 30 seconds), or an Alarm will be Triggered. If you lock the doors, regular Arming will override Passive Arming; there will be no Entry Delay. See the PROGRAMMING information on page 12 to activate the PASSIVE ARMING mode, as well as to select the ENTRY Delay time.

To Passively Arm the system:

Remove the key from the ignition switch.

Exit the vehicle, and close all the doors. (The system will not

Arm while any of the doors are open.)

After the last door is closed:

The Status Monitor's LED turns on for 30 seconds, then starts flashing. ® The system is now Armed.

seconds after the last door is closed

the system disarms when you insert the key and turn it to "on'

the system disarms when you insert the key and turn it to "on'

To Disarm the Passively Armed system: Enter the vehicle through a front door. The Entry Delay begins:

The Status Monitor's LED turns on (no flashing.) @ Insert the key into the ignition switch and turn it to "ON" before the Entry Delay ends.*

The LED turns off. The system is now Disarmed.

You may also Disarm the system following any of the methods described on page 6.

NOTE: If your vehicle's tail and marker lights turn on for 2 seconds when the ignition key is turned to "ON", the Trigger Memory was activated; something Triggered an Alarm while you were away from the vehicle.

lights for 30 seconds (pre-arm-ing) then starts flashing (system is armed)

turns on (no . flashing) during the entry delay

* If the Entry Delay time elapses before the ignition switch is turned to "ON", an Alarm will be Triggered. To Disarm the system during an Alarm, insert the ignition key and turn it to "ON", or press and release the remote control's unlock button.

0 0

Post a comment