Res Ecu

Large Foam Tape

(e) Apply one large foam tape onto the RES ECU as shown. (Fig. 4-4)

(f) Connect the RES harness' ECU connectors (8P and 20P) to the RES ECU. (Fig. 4-5)

^ (g) Using 3M™ Prep Solvent-70, clean the RES ECU install area.

Install the ECU mounting bracket with one bolt to the right side of the glove box area as shown. (Fig. 4-5)

^^ (1) Verify the bolt is tightened secured.

^ (2) Press the RES ECU to right side of the vehicle's body in the glove box area.

(h) Insert the BUS ECU mounting bracket into the indicated bracket slots on the BUS ECU. (Fig. 4-6)

(1) Insert the mounting bracket into the correct ECU's slot.

(2) The bracket is permanently attached once installed.

(3) Ensure the bracket is firmly attached to the ECU.

(i) Install the BUS ECU mounting bracket with one bolt to the right side of the glove box area as shown. (Fig. 4-7)

(1) Verify the bolt in tightened secured.

Side Cutter

Wire Tie

RES Harness' 3P (White)

RES Harness

Side Cutter

Wire Tie

Wire Tie

RES Harness' 1P (White)

RES Harness' 1P (White)

Wire Tie

RES Harness' e)

RES Harness' e)

RES Harness' 1P (White)

RES Harness' 1P (White)

(j) Connect the RES harness' white 5P connector to the BUS ECU. (Fig. 4-8)

(k) Secure the RES harness to the vehicle harness with one wire tie. (Fig. 4-8)

(l) Route the RES harness' white 3P connector and white 1P connectors toward the passenger's side cowl area. (Fig. 4-8)

5. RES Harness Installation (continued)

(a) Locate and remove the tape securing the vehicle harness' white 3P connector from the right side of the glove box area. (Fig. 5-1)

+1 0

Post a comment