S

Side Cutter

RES Harness' 3P (White)

Vehicle Harness' 3P (White)

Side Cutter

RES Harness' 3P (White)

Vehicle Harness' 3P (White)

RES Harness' 1P Connectors

(b) Plug in the RES harness' white 3P connector to the vehicle harness' white 3P connector. Secure the 3P connector to the vehicle harness with one wire tie. (Fig. 5-2)

(c) Secure the RES harness to the vehicle harness with one wire tie. (Fig. 5-2)

6. Tags and Labels Installation.

(a) Hang the shift tag on the shift lever. (Fig. 6-1)

(b) Remove one of the remote controls from its protective bag. With the utility knife, neatly cut a slit to open the bag. (Fig. 6-2)

(c) Using 3Mtm Prep Solvent-70, clean the area indicated on the remote control key.

(1) When cleaning with 3MTM Prep Solvent-70, follow the manufacturer's directions. Do not allow cleaner to air dry.

(d) Remove the backing sheet and attach the key label to the remote control as shown.

(1) Use a piece of clean adhesive tape to lift the label off its protective backing sheet.

(2) Do not touch the label's adhesive surface.

(e) Attach a key tag to each master key ring. (Fig. 6-3)

(f) Using 3MTM Prep Solvent-70, clean the area indicated on the engine compartment cover as shown. (Fig. 6-4)

(1) Do not allow cleaner to air dry.

^^ (g) Remove the backing sheet and attach the warning label to the engine compartment cover 10mm above the vehicle label's placement box. Do not touch the label's adhesive surface. (Fig. 6-4)

Warning Label

Line Up With Bottom of Window Etching

Warning Label

(h) Using household Windex, clean the inside surface of the front door's windows.

(1) When cleaning with household Windex, follow the manufacturer's directions.

(i) Place the window labels on the inside surface of the front door's windows as shown.

(1) Use a piece of clean adhesive tape to lift the labels off their protective backing sheet.

(2) Do not touch the labels' adhesive surface.

7. Registration Setting Procedure.

(1) Do not close the hood during the registration setting procedure. (Steps b-e)

(b) Temporarily reconnect the vehicle's negative battery cable. (Fig. 7-2)

(1) Do not touch the positive terminal with any tool when replacing the cable.

(c) Locate and disconnect the tape securing the RES harness' white 1P connectors from the passenger side cowl area and connect it. (Fig. 7-3)

(d) Close all doors. Insert the key into the ignition switch and turn it from LOCK to ON 5 times (ending at ON). (Fig. 7-4) The hazard lights flash once. (Fig. 7-4) Turn the key to the "OFF" position.

0 0

Post a comment