RavU LO

Take out the discharged battery and cover using a coin. put in a new battery with the positive 5. Install the battery case cover and then install the module into the key frame. Close the cover. 6. When pushing either switch on the wireless key, make sure the indicator light comes on. Make sure the negative side o faced correctly. Do not replace t hands. Water ma rust. Do not touch or nents inside the may interfere wit Be careful not to when inserting t dust...

Toyota 2az-fe Octane

Select Octane Rating 87 (Research Octane Number 91) or higher. Use of unleaded gasoline with an octane rating or research octane number lower than stated above will cause persistent heavy knocking. If it is severe, this will lead to engine damage. If you detect heavy knocking even when using the recommended fuel, or if you hear steady knocking while holding a steady speed on level roads, consult your Toyota dealer. However, occasionally, you may notice light knocking for a short time while...

Emissions Inspection and Maintenance IM programs

Some states have vehicle emission inspection programs which include OBD (On-Board Diagnostics) checks. The OBD system monitors the operation of the emission control system. When the OBD system determines that a problem exists somewhere in the emission control system, the malfunction indicator lamp comes on. In this case, your vehicle may not pass the I M test and need to be repaired. Contact your Toyota dealer to service the vehicle. Even if the malfunction indicator lamp does not come on, your...

Do It Yourself Maintenan

Checking battery condition Battery recharging precautions Checking and replacing fuses Adding washer fluid Replacing light bulbs Checking battery condition Precautions Do not cause a spark from the battery with tools. Do not smoke or light a match near the battery. Avoid contact with eyes, skin or clothes. Wear protective safety glasses when working near the battery. Keep children away from the battery. If electrolyte gets in your eyes, flush your eyes with clean water immediately and get...

Rear window wiper and washer

To turn on the rear window wiper, twist the lever knob upward. The key must be in the ON position. To squirt washer fluid on the rear window, twist the knob upward or downward as far as it will go (position 3 or 4). The knob automatically returns from these positions after you release it. The rear window wiper operates while the washer squirts. For instructions on adding washer fluid, see Adding washer fluid on page 386 in Section 7-3. Do not operate the rear wiper if the rear window is dry. It...

Traction control system

The traction control system automatically helps prevent the spinning of the front wheels (two-wheel drive models) or 4 wheels (four-wheel drive models) when the vehicle is started or accelerated on slippery road surfaces. When the ignition key is turned to ON, the system automatically turns on. Under certain slippery road conditions, full traction of the vehicle and power to the front wheels (two- wheel drive models) or 4 wheels (four- wheel drive models) cannot be maintained, even though the...

Enhanced vehicle stability control system fourwheel drive vehicles

The vehicle stability control system helps provide integrated control of the such systems as the anti-lock brake, brake assist, traction control, engine control, electric power steering, active torque control 4WD. This system automatically controls the brakes, engine and power steering as well as driving force to all the 4 wheels to help prevent the vehicle from skidding when cornering on a slippery road surface or operating steering wheel abruptly. This system activates when the vehicle speed...

Malfunction In Active Torque Control For 2012 Toyota Rav4

The light warns that when there is a problem somewhere in active torque control 4WD system. The light will come on when the ignition key is turned to ON, and will go off after about a few seconds. If the warning light does not come on when the ignition key is turned to ON, contact your Toyota dealer to service the vehicle. If the 4WD warning light flashes This indicates that the driveline temperature has become too high. Without turning off the engine, do either of the following to cool the...

Active torque control WD system

The active torque control 4WD system controls the engine torque that is applied to the rear wheels according to the driving conditions and road conditions. When the vehicle's driving conditions are stable such as driving straight ahead, the engine torque is applied to only the front wheels. When the vehicle surfaces, such as s snow, or if the ' pushing the four switch to ensure th is applied to the 4 When the four-whee pushed, the four-whe light blinks twice and four-wheel drive lock To cancel...

Windshield wipers and washer

Toyota Wiper Washer Instruction Manual

To turn on the windshield wipers, move the lever to the desired setting. The key must be in the ON position. For a single sweep of the windshield, push the lever up and release it. The INT band lets you adjust the wiping time interval when the wiper lever is in the intermittent position position 1 . Twist the band upward to increase the time between sweeps, and downward to decrease it. To squirt washer fluid, pull the lever toward you. If the windshield wipers are off, they will operate a...

Tilt and telescopic steering wheel

To adjust the steering wheel position, push down the lock release lever. Then tilt the steering wheel to the desired angle, push or pull it to the desired steering column length and return the lever to its original position. Do not adjust the steering wheel while the vehicle is moving. Doing so may cause the driver to mishandle the vehicle and an accident may occur resulting in death or serious injuries. After adjusting the steering wheel, try moving it up and down or forward and rearward to...

Name Manuals Fuses On Toyota Rav4 2002

Where Fuse Beam Toyota Rav4 2002

ECU-B2 7.5 A Air conditioning system, power windows 5. RSE 7.5 A Rear seat entertainment system 8. ECU-B 10 A Wireless remote control system, electric power steering system, main body ECU, power door lock, front passenger occupant classification system, clock, audio system, meters and gauges 9. DOME 10 A Ignition switch light, interior light, vanity lights, luggage compartment light, front personal lights, foot lights 10. HEAD LH 10 A Left-hand headlight high beam 11. HEAD RH 10 A Right-hand...

Outside temperature display

Ambient Temp Sensor For Corolla 2006

Trip meter reset knob Resets the two trip meters to zero, and also change the meter display. To change the meter display, quickly push and release the knob. The meter display changes in the order from the odometer to trip meter A to trip meter B, then back to the odometer each time you push. To reset the trip meter A to zero, display the meter A reading, then push and hold the knob until the meter is set to zero. The same process can be applied for resetting the trip meter B. The displayed...

Engine immobilizer system

How Code Key Land Cruiser 1kz

The engine immobilizer system is a theft prevention system. When you insert the key in the ignition switch, the transponder chip in the key's head transmits an electronic code to the vehicle. The engine will start only when the electronic code in the chip corresponds to the registered ID code for the vehicle. The system is automatically set when the key is removed from the ignition switch. The indicator light will start flashing to show the system is set. In the following cases, contact your...

To activate the system push the Auto Lsd switch with the vehicle stopped

The AUTO LSD indicator light will come on and remain on while the system is on. While the system is operating, the slip indicator light will also flash. To cancel the system, push the AUTO LSD switch once again and the AUTO LSD indicator light will go off. If the vehicle speed exceeds 50 km h 31 mph , this system will be cancelled automatically. The AUTO LSD indicator light will come on for a few seconds when the ignition key is turned to ON. If the indicator light does not come on when the...