Installation

1. INSTALL CAMSHAFT POSITION SENSOR NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.

(a) Apply a light coat of engine oil to the O-ring of the sensor.

(b) Install the sensor with the bolt. Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)

(c) Connect the sensor connector.

2. INSTALL AIR CLEANER CAP (See page ES-413)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. CHECK FOR ENGINE OIL LEAKAGE

5. INSTALL NO. 1 ENGINE COVER (See page ES-414)

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment