Installation

1. INSTALL ECM

(a) Install the 2 brackets to the ECM with the 4 screws. Torque: 3.0 N*m (30 kgf*cm, 27 in.*lbf)

(b) Connect the 2 ECM connectors. NOTICE:

When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.

(1) Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:

Make sure that the 2 levers are securely lowered.

(c) Install the ECM with the 3 bolts.

2. INSTALL AIR CLEANER CASE

(a) Install the air cleaner case with the 3 bolts. Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

(b) Connect the harness clamp.

3. INSTALL AIR CLEANER CAP (See page ES-413)

4. CONNECT CABLE TO NEGATIVE BATTERY

TERMINAL

5. PERFORM REGISTRATION

(a) When replacing the ECM, the Vehicle Identification Number (VIN) must be input into the replacement ECM (see page ES-13).

(b) When replacing the ECM, perform the vehicle stability control system recognition in the ECM (see page CC-12).

6. RESET MEMORY

(a) When replacing the ECM, perform the RESET MEMORY procedure (A/T initialization) (see page AX-18).

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment