Repair Or Replace Harness Or Connector

Tester Connections

Specified Conditions

B6-1 (G2+) - B30-99 (G2+)

Below 1 Q

B6-2 (G2-) - B30-9B (G2-)

Below 1 Q

Standard resistance (Check for short)

Tester Connections

Specified Conditions

B6-1 (G2+) or B30-99 (G2+) - Body ground

10 kQor higher

B6-2 (G2-) or B30-98 (G2-) - Body ground

10 kQor higher

CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR)

(a) Check the CMP sensor installation. OK:

Sensor is installed correctly.

SECURELY REINSTALL SENSOR

CHECK VALVE TIMING (See page ES-77)

ADJUST VALVE TIMING

CHECK CAMSHAFT

(a) Check the teeth of the camshaft. OK:

Camshaft teeth do not have any cracks or deformation.

REPLACE CAMSHAFT

REPLACE CAMSHAFT POSITION SENSOR

NEXT

CHECK WHETHER DTC OUTPUT RECURS

(a) Connect the intelligent tester to the DLC3.

(b) Turn the ignition switch ON.

(e) Start the engine.

(f) Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES.

Result

Display (DTC Output)

Proceed To

No output

A

Display (DTC Output)

Proceed To

P0340

If the engine does not start, replace the ECM.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment