At this time buzzer sounds for seconds

3. Turn the ignition switch OFF.

b. Perform steering angle, master cylinder pressure, yaw rate and deceleration sensors zero point calibration.

1. Using SST, connect terminals Ts and CG of DLC3.

Sst 09843 18040

Fig. 20: Identifying DLC3 Connector Terminals

Fig. 20: Identifying DLC3 Connector Terminals

SST 09843-18040

Shift the shift lever to P position. Turn the ignition switch ON.

Keep the vehicle in the stationary condition on the flat place for 4 sec. or more.

After turning the steering wheel to an angle of 5 degrees or more, set it in the straight-ahead position and press the VSC OFF (TRAC OFF) switch 3 times within 3 sec.

2001 BRAKES ABS With EBD & Trac & VSC System - Diagnostics - Sequoia

6. Check that the VSC buzzer sounds for 3 seconds.

NOTE: If the VSC buzzer does not sound, do the zero point calibration again.

If the VSC buzzer does not sound, check the VSC BUZZER CIRCUIT .

When setting the steering wheel in the straight-ahead position, the tires shall be positioned within +/- 0.4 degrees from the straight ahead.

7. Turn the ignition switch OFF.

8. Disconnect terminals Ts and CG of DLC3.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment