Oil Pump

Disassembly

Place oil pump on torque converter while working on pump. Remove seal rings from rear of oil pump. Remove bolts from rear of pump assembly. Remove stator shaft from pump housing. See Fig. 26.

Place reference mark on drive and driven gears for reassembly reference and remove from pump housing. If oil seal requires replacement, pry seal from housing with a screwdriver.

Cleaning & Inspection

1. Clean all components in solvent. Dry with compressed air. Inspect contact surfaces between housing and driven gear for wear. Check gears for wear and body crescent for damage. Check pump gear contact surface on stator shaft for damage and wear.

2. Measure inside diameter of oil pump housing and stator shaft bushings. Measure driven gear-to-housing clearance and gear tip clearance. Using feeler gauge and straightedge, measure gear side clearance between pump housing face and top of gears. See Fig. 27. See OIL PUMP CLEARANCE SPECIFICATIONS table.

3. If clearance(s) are not within specifications, replace worn component(s). Pump gears must be replaced as

2001-05 AUTOMATIC TRANSMISSIONS A340E & A340F Overhaul a matched set. If bushing diameter exceeds specification, oil pump housing or stator shaft must be replaced.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment