Thrust washers and races should be coated with petroleum jelly prior to installation

Reassembly

1. Coat "O" rings with ATF. To complete reassembly, reverse disassembly procedure. Ensure piston return spring snap ring or oil seal ring is fully seated and ring ends do not align with claw area on spring retainer of piston return spring.

2. With clutch drum open area facing upward, install plates and discs, starting with a plate and then alternating with a disc. Install appropriate number of plates and discs.

3. Install flange with flat end facing toward disc. Install snap ring. Place clutch drum on overdrive support. Measure piston stroke with a dial indicator while applying 57-114 psi (4-8 kg/cm2 ) to piston supply port. See Fig. 35.

4. See DIRECT CLUTCH PISTON STROKE SPECIFICATIONS table. If piston stroke is not within specifications, check for incorrectly assembled components. Recheck piston stroke measurement.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment