How To Change Shocks On 2004 Sequoia

Sequoia Bushing Replacement Parts

G00008405

Fig. 5: Location Of Power Steering Gear Mounting Bolts & Nuts Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

4. Install wheels. Tighten all remaining nuts and bolts to specification. See TORQUE

SPECIFICATIONS . Lower vehicle. Check front wheel alignment. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES .

2002-04 SUSPENSION Front - Sequoia

SHOCK ABSORBER Removal & Installation

Raise and support vehicle. Remove wheel. Remove nuts and washer retaining shock absorber to bracket. DO NOT remove bolt. Remove nuts, shock absorber and coil spring. To install, reverse removal procedure.

STABILIZER BAR

Removal

Raise and support vehicle. Remove 2 nuts and disconnect stabilizer bar links from lower control arms. Remove bolts, nuts and stabilizer bar with cushions and brackets. Remove stabilizer bar link, 2 retainers and bushings from stabilizer bar.

Inspection

Inspect bushings for wear, and replace as necessary.

Installation

To install, reverse removal procedure. Tighten stabilizer-to-lower control arm nuts to specification. See TORQUE SPECIFICATIONS .

UPPER CONTROL ARM

Removal

1. Raise and support vehicle. Remove wheel. Remove shock absorber with coil spring. See SHOCK ABSORBER .

2. Remove speed sensor and wire harness clamp from steering knuckle and upper control arm. Remove cotter pin, loosen nut and disconnect upper ball joint. Support steering knuckle, and set aside. Remove 4 clips and fender apron seal. See Fig. 6 .

3. Disengage 2 brake lines and fuel line. Remove nut and brake line clamp. Remove nut, bolt, 2 washers and upper control arm.

2002-04 SUSPENSION Front - Sequoia

Stabalizer Arm Toyota Hilux 2004
Fig. 6: Exploded View Of Upper Control Arm Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2002-04 SUSPENSION Front - Sequoia

Bushing Replacement

Using a chisel and hammer, pry up flange of bushing. Using Split Clamp (09613-26011) and press, remove bushing. Press in new rear bushing.

Installation

To install, reverse removal procedure. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS .

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • BETTYE SHEPHERD
    How to change brake lines on a 1997 Toyota Corolla?
    8 years ago
  • AMINA
    How to change shocks on 2004 sequoia?
    6 years ago
  • leena somervuori
    Where to buy strutts an shocks for 2003 toyoto sequia?
    4 years ago
  • Stephen
    How to Install sequoia Stabilizer Links?
    3 years ago
  • Eleleta
    How to remove 2006 toyota sequoia rear shocks?
    3 years ago
  • anna
    How to chang shocks bushing set toyota sequoia?
    3 years ago
  • Bobby
    How to remove rear shocks on a 2004 sequoia?
    3 years ago
  • jonatan
    How to replace rear Sequoia shocks?
    2 years ago
  • Marjo
    How to replace rear shocks on 2004 sequoia?
    2 years ago
  • VICKI
    How to replace 2003 sequoia 2 wheel drive rear shock?
    9 months ago

Post a comment