Installation

1. INSTALL DRIVE PLATE

NOTE:

• The mounting bolts are tightened in 2 progressive steps (steps b and d ).

• If any one of the mounting bolts is broken or deformed, replace it.

NOTE: a. Apply adhesive to 2 or 3 threads of the mounting bolt end.

Adhesive:

Part No. 08833-00070, THREE BOND 1324 or equivalent

2004 ENGINE Engine Unit (4WD) - Sequoia

G02927237

Fig. 12: Applying Adhesive To Threads Of Mounting Bolt End Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Install the front spacer, drive plate and rear spacer on the crankshaft.

c. Install and uniformly tighten the 8 mounting bolts in several passes, in the sequence shown.

If any one of the mounting bolts does not meet the torque specification, replace the mounting bolt.

2004 ENGINE Engine Unit (4WD) - Sequoia

G02927238

Fig. 13: Installing Front Spacer, Drive Plate & Rear Spacer On Crankshaft Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

d. Mark the mounting bolt with paint.

e. Retighten the mounting bolts by 90° in the numerical order shown.

f. Check that the painted mark is now at a 90° angle to (e).

2004 ENGINE Engine Unit (4WD) - Sequoia

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment